Andis 60130 Kullanım ve Bakım Talimatları Kılavuzu - Sayfa 3

Elektrikli Tıraş Makinesi Andis 60130 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Talimatları Kılavuzu indirin. Andis 60130 16 sayfaları.

6. Keep the cord away from heated surfaces.

7. Never drop or insert any object into any opening.

8. Do not use outdoors or operate where aerosol (spray) products

are being used or where oxygen is being administered.

9. Do not use this appliance with a damaged or broken blade or

comb, as injury to the skin may occur.

10. To disconnect turn control to "OFF" then remove plug from outlet.

11. WARNING: During use, do not place or leave appliance

where it may be (1) damaged by an animal or (2) exposed to

the weather.

12. This appliance is intended for trimming purposes only.

13. Keep the air openings free of lint, hair, and similar objects.

SAVE THESE INSTRUCTIONS

THIS PRODUCT IS INTENDED FOR HOUSEHOLD ANIMAL USE ONLY

OPERATING INSTRUCTIONS

To reduce the risk of electric shock, this appliance has a polarized plug (one blade is

wider than the other). This plug will fit in a polarized outlet only one way. If the plug

does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a

qualified electrician to install the proper outlet. Do not change the plug in any way.

Before starting clipper remove blade guard. Plug cord into electrical outlet, operate at

120 volt, 60 cycle AC electrical current or as noted on the unit. To start clipper move

switch button to "ON" position, to stop, move switch button back to original position.

After using your Andis clipper, rewrap cord and store in a safe place.

BLADE SETS

(Contents may vary by kit)

Your Andis clipper comes with a Size 10 blade (on clipper) and an additional Size 7FC

blade. A Size 4FC blade is also available for purchase (Figure A). The blade size is

indicated on the blade set. Use the clipping guide in this manual to find the

approximate length of cut for each blade set.

REMOVING BLADE SET

To remove blade set, first make sure your clipper motor is switched "OFF". Push

blade release button on top of clipper (Figure B). After the blade releases from the

clipper, slide it off the blade hinge (Figure C). NOTE: Hair may accumulate in the front

cavity of the housing under the blade. If this happens, you can clean out the hair by

brushing out the cavity with a small brush or an old toothbrush while the blade is off

the clipper.

REPLACING OR CHANGING BLADE SET

To replace or change your blade set, slide the blade bracket onto the hinge of the

clipper (Figure C). Push the blade toward the clipper to lock into position.