Electrolux HOOV11E Kurulum Kılavuzu - Sayfa 19

Havalandırma Davlumbazı Electrolux HOOV11E için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Electrolux HOOV11E 32 sayfaları. Built-in hood for electric oven
Ayrıca Electrolux HOOV11E için: Kullanıcı Kılavuzu (24 sayfalar)

Sayfayı Yazdır

• Connect the appliance to the power supply in a

permanent way with an H07 RN-F type cable

dim. 3G1,5mmq;

• Install the power cable in a metal or rigid

plastic pipe without any sharp parts;

• Install ahead of the appliance an omnipolar

switch of suitable capacity with contact gap of

at least 3 mm. Install the switch in the

building's electrical system, in the immediate

vicinity of the appliance;

• If required by local standards and regulations,

a RCBO circuit breaker with Idn 300mA class

A must be provided in the power supply circuit

by the installer;

• Appliance max. leakage current is 0.75 mA;

• Install ahead of the appliance a device

(interlocked plug, lockable switch or similar

devices) lockable in the open position during

maintenance;

• Connect the appliance to an efficient earthing

system. For that purpose, the connection

terminal block has a terminal with the symbol

for connecting the earth wire;

• Also, include this device in an equipotential

system (see chap. F.6.3). Make sure the oven

on which the hood is mounted has the relevant

terminal. This terminal must be in electrical

contact with all fixed exposed metal parts of

the hood and must allow the connection of a

conductor having a nominal cross-section area

of 2.5 mm2 to 6 mm2; this connection is made

with the screw marked

near the power cable entry.

F.7.2 Power cable installation

To connect the power cable to the appliance,

proceed as follows:

1. Open the Technical Compartment;

2. Connect the cables (NOT SUPPLIED - see the

technical characteristics on F.7.1 - "Power

cable") on "VOLTAGE" female connector,

using the male connector supplied, following

the instructions the relevant Wiring diagram;

3. Close the Technical Compartment.

, located externally

F.7.3 Hood-oven interface cable

The hood is supplied with an Interface Cable, it is

already connected on main-board in CN3 position;

to connect the hood to oven proceed as follows:

1. Remove the left side panel of the oven, as

indicated in the "Oven Installation Manual";

2. Remove the pre-cut sheet on the oven base to

obtain a 21mm hole;

3. Insert the male thread curve supplied, relevant

to the interface cable, and secure it with the

nut supplied;

4. Remove the Touch Screen Panel from the

oven, as indicated in the "Oven Service

Manual";

5. Insert the interface cable connectors on the

relevant positions indicated X28-A;