Electrolux HOOV11E Kurulum Kılavuzu - Sayfa 21

Havalandırma Davlumbazı Electrolux HOOV11E için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Electrolux HOOV11E 32 sayfaları. Built-in hood for electric oven
Ayrıca Electrolux HOOV11E için: Kullanıcı Kılavuzu (24 sayfalar)

Sayfayı Yazdır

COMMISSIONING AND SETTINGS

Introduction

G.1

CAUTION

Make sure the appliance is

connected to a water

drainage system, a power

socket, and to the oven

via the oven/hood

Interface cable.

Switch the oven on as indicated in the Installation

Manual (chap. G "COMMISSIONING AND

SETTINGS").

CAUTION

During operation, pay

attention to the hot areas

of the outer surface. Do

not place objects on the

outlets located at the

upper rear of the

appliance.

G.2 Oven settings

G.2.1 Single oven setting

In the case of installing the hoods, 922718,

922719 or 922720, follow these procedures when

switching on the oven for the first time, set the

parameter "347 Hood" on "Level 4", following the

procedure:

AL01 IM_HO_L1_L2_L3_L4

with TOUCH Oven (see annex document).

AL02 IM_HO_L1_L2_L3_L4

with DIGIT Oven (see annex document).

G.2.2 Stacking ovens mode setting

In the case of installing the hoods, 922721 or

922722,

•

on MASTER oven follow the previous G.2.1

and setting the parameter "347 Hood" on

"Level 4;

•

on SLAVE oven, when switching on for the

first time, set the parameter "347 Hood" on

"Level 3", following the procedure:

AL01 IM_HO_L1_L2_L3_L4

with TOUCH Oven (see annex document).

AL02 IM_HO_L1_L2_L3_L4

with DIGIT Oven (see annex document).

G.2.3 Correct oven setting check

The previous procedures must be completed in

order to ensure correct operation of the hood and

to allow its use.

The checking procedure consists of 2 main steps:

1. Only for Level 4 Hood, check that the hood

symbol is present on the oven interface (Touch

Screen Panel); or

2. test hood operation by switching the oven on

and start a test program. Simulate oven door

opening and closing: the fan should change

speed.