Electrolux RH30WC55GS Kurulum, Kullanım ve Bakım Kılavuzu - Sayfa 10

Havalandırma Davlumbazı Electrolux RH30WC55GS için çevrimiçi göz atın veya pdf Kurulum, Kullanım ve Bakım Kılavuzu indirin. Electrolux RH30WC55GS 20 sayfaları. 30” et 36” hotte aspirante
Ayrıca Electrolux RH30WC55GS için: Fabrika Parça Kataloğu (4 sayfalar), Broşür ve Teknik Özellikler (2 sayfalar), Kurulum, Kullanım ve Bakım Kılavuzu (20 sayfalar), Kurulum, Kullanım ve Bakım Kılavuzu (21 sayfalar), Kurulum, Kullanım ve Bakım Kılavuzu (20 sayfalar), (İngilizce) Kurulum, Kullanım ve Bakım Kılavuzu (25 sayfalar), (Fransızca) Manual D'installation, Utilisation Et D'entretien (21 sayfalar)

Sayfayı Yazdır
Electrolux RH30WC55GS Kurulum, Kullanım ve Bakım Kılavuzu
Installing the hood
10
10
10
10
10

Install framing for hood support

Install framing for hood support
Install framing for hood support
Install framing for hood support
Install framing for hood support
• If drywall is present, mark the screw hole
locations. Remove the template.
• Cut away enough drywall to expose 2 vertical
studs at the holes location indicated by the
template.
Install two horizontal supports at least 1" x 6"
between two wall studs at the bottom and top
mounting holes installation location.
• The horizontal support must be flush with the
room side of the studs.
Use cleats behind both sides of the support to
secure to wall studs.
• Reinstall drywall and refinish.
IMPOR
IMPOR
IMPORT T T T T ANT
ANT
ANT
ANT- - - - - Framing must be capable of
IMPOR
IMPOR
ANT
supporting 100 lbs.
supporting 100 lbs.
supporting 100 lbs.
supporting 100 lbs.
supporting 100 lbs.
Framing must be capable of
Framing must be capable of
Framing must be capable of
Framing must be capable of
8-1/2"min. opening for ductwork
View From Rear
1"x6" Min.
Mounting
Support
Centerline of
Installation
Space

Mounting the hood

Mounting the hood
Mounting the hood
Mounting the hood
Mounting the hood
2 people are required to lift and position the hood
onto the mounting screws.
• Place the template on the wall along the horizon-
tal line, make sure the template is leveled and
centered with the centerline.
• Mark "upper" screw holes locations in the wall.
• IMPORTANT. Check to be sure that hole locations
are leveled and correctly centered by the vertical
centerline.
• Drive "upper" wood screws by hand. Leave ¼ " of
distance between the screw head and the wall.
• Remove the grease filter and mount the hood
onto the "upper" screws.
Cleats
• Mark "lower" wood screw holes locations in the
wall using a pencil.