Electrolux RH36WC55GS Kurulum, Kullanım ve Bakım Kılavuzu - Sayfa 12

Havalandırma Davlumbazı Electrolux RH36WC55GS için çevrimiçi göz atın veya pdf Kurulum, Kullanım ve Bakım Kılavuzu indirin. Electrolux RH36WC55GS 20 sayfaları. 30” et 36” hotte aspirante
Ayrıca Electrolux RH36WC55GS için: Fabrika Parça Kataloğu (4 sayfalar), Broşür ve Teknik Özellikler (2 sayfalar), Kurulum, Kullanım ve Bakım Kılavuzu (20 sayfalar), Kurulum, Kullanım ve Bakım Kılavuzu (20 sayfalar), (İngilizce) Kurulum, Kullanım ve Bakım Kılavuzu (25 sayfalar), (Fransızca) Manual D'installation, Utilisation Et D'entretien (21 sayfalar)

Sayfayı Yazdır
Electrolux RH36WC55GS Kurulum, Kullanım ve Bakım Kılavuzu
Installing the hood
12
12
12
12
12

Making the electrical connections

Electrical Shock Hazard
Warning: Turn off power at the service panel before
wiring this unit.
120 VAC, 15 or 20 Amp cir
120 V
120 V
120 V
120 V
AC, 15 or 20 Amp circuit r
AC, 15 or 20 Amp cir
AC, 15 or 20 Amp cir
AC, 15 or 20 Amp cir
ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED WITH AN ELECTRICAL
JUNCTION BOX WITH 3 WIRES, ONE OF WHICH
(GREEN/YELLOW) SERVES TO GROUND THE
APPLIANCE. TO PROTECT YOU AGAINST
ELECTRIC SHOCK, THE GREEN AND YELLOW
WIRE MUST BE CONNECTED TO THE
GROUNDING WIRE IN YOUR
HOME ELECTRICAL SYSTEM, AND IT MUST
UNDER NO CIRCUMSTANCES BE CUT OR REMO-
VED.
Failure to do so can r
Failur
Failur
Failur
Failur
e to do so can result in death or electrical
e to do so can r
e to do so can r
e to do so can r
shock.
shock.
shock.
shock.
shock.
• Remove junction box cover and knockout on the
top left side.
cuit r
cuit r
cuit requir
cuit r
equired.
equir
equir
equir
ed.
ed.
ed.
ed.
esult in death or electrical
esult in death or electrical
esult in death or electrical
esult in death or electrical
Knockout
Junction box
cover
• If not already done, install 1/2" conduit connector
in j-box.
House
wiring
U.L. listed
wire nut
• Run black (live), white (neutral), and green (earth)
wires (#14 AWG) according to the National
Electrical Code or CSA Standards and local
codes and ordinances in 1/2" conduit from power
supply to j-box.
• Connect black, white, and green wires from
power supply to black, white, and green/yellow
wires in j-box respectively.
• These connections should be done while always
making reference to the electrical diagram found
inside the hood.
• Close j-box cover and reapply screws.
Metal electrical
conduit