Electrolux 50 Series Kullanıcı El Kitabı - Sayfa 3

Elektrikli Süpürge Electrolux 50 Series için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Electrolux 50 Series 8 sayfaları. Household type

Sayfayı Yazdır

BEFORE YOU START

CHECK THE VOLTAGE

First check the voltage shown on the data plate (see rear view) to make sure that the

cleaner is of the correct voltage for your electricity supply. If it is not, do not use the

cleaner but refer back to your dealer.

CONNECTING TO YOUR ELECTRICITY SUPPLY

Permanently connected to the cleaner is a mains supply (2-core) cable fitted with a non-

rewirable plug incorporating a 13A fuse.

In the event of the fuse requiring replacement, the fuse cover should be removed using

a small screwdriver. The old fuse MUST be replaced by a 13A ASTA approved BS1362

fuse or a BSI approved fuse. The cover must be replaced before the plug is used again.

In the event of loss of the fuse cover, replacements can be obtained from your Electrolux

retailer and must be of the same colour as indicated by the coloured insert on the base

of the plug.

If difficulty is experienced in obtaining a replacement, contact an Electrolux Service Agent

or phone 08706 055055.

In no circumstances must the plug be used without a correct fuse cover fitted.

If the plug that is fitted to your appliance is not suitable for your socket outlet, it must

be cut off and the appropriate plug fitted.

Remove the fuse from the cut off plug.

The cut off plug should then be disposed of to prevent the hazard of shocks in case it

should be plugged into a 13 amp socket in another part of your home.

The wires in the mains cable of this appliance are coloured in accordance with the

following code: Blue: Neutral. Brown: Live.

As the colours of the wires in the mains cable of this appliance may not correspond with

the coloured markings identifying the terminals in your plug, proceed as follows:

The wire which is coloured blue must be connected to the terminal which is marked with

the letter N or coloured black.

The wire which is coloured brown must be connected to the terminal which is marked

with the letter L or coloured red.

If using a three-pin plug, do not make any connection to the terminal marked with the

letter E or by the earth symbol or coloured green or green-and-yellow. This cleaner is

double insulated and no earth connection is necessary.

It is in your interest to ensure that the plug is correctly attached to the mains cable. In

case of doubt, have it done by a qualified electrician, as Electrolux cannot regard the

repair of faults on the plug connection as a service that can be given free of charge under

the terms of the guarantee.

Fuse

Cover

71520

Blue

Fuse

13 Amp Fuse

Brown

Cord

Clamp

9/21/05, 10:09 AM