Electrolux 50 Series Kullanıcı El Kitabı - Sayfa 6

Elektrikli Süpürge Electrolux 50 Series için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Electrolux 50 Series 8 sayfaları. Household type

Sayfayı Yazdır

HOW TO MAINTAIN

The instructions given in this booklet serve as a guide to routine maintenance. Keep the

vacuum cleaner at top operating efficiency. Clean the filter and empty the dust container

regularly. If the dust container is visibly full before finished cleaning, empty as needed.

Dust Container and Motor Filter

Empty the dust container and clean the motor filter regularly to keep the vacuum cleaner

operating efficiently. Make sure the filter is securely attached in place before vacuuming.

Failure to replace the filter will allow dust to enter the motor section which will damage

the vacuum cleaner. Some fine particles can restrict airflow very quickly and will decrease

performance even before the dust container appears full. For that reason, when

vacuuming carpet fresheners or cleaners, powder, plaster dust, or similar fine substances,

the dust container and filter may need cleaning more often.

NOTE: Turn off the switch and unplug the electrical cord before emptying the

dust container and cleaning the motor filter.

Press the dust container latch, located

below the electrical cord, and rotate the

dust container off the unit. Grasp the

motor filter and pull up to remove.

Shake dust container contents into a

suitable container. Brush dust and dirt

from motor filter. If further cleaning is

desired, hand launder the washable

motor filter in warm water using a mild

detergent. Air dry thoroughly before

returning it to the dust container.

Replace motor filter into top of dust

container so rim of filter is seated

completely inside the container. Place the

dust container tab into the slot in the unit.

Pivot the sections together until the dust

container latch locks the container in

place.

A damaged or extremely soiled motor filter should be replaced. Pull back on the rubber

gasket to remove the used motor filter from the filter support frame. Keep the frame and

discard the used motor filter. Put the new filter over the frame and secure the lip of the

frame into the rubber gasket.

Additional filters are available from the Electrolux Customer Care line, 08706 055055.

71520

Motor

Filter

Latch

Tab

Slot

9/21/05, 10:09 AM