Electrolux Beam Kurulum Kılavuzu - Sayfa 6

Elektrikli Süpürge Electrolux Beam için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Electrolux Beam 16 sayfaları. Central

Sayfayı Yazdır

3 Plan where the pipe/ductwork can be hidden

Obviously, if at all possible, all the pipe work that joins the appliance to the inlets in

the wall, should be hidden. Ultimately, you may now need to change the location of

the actual appliance and/or inlets, if the route is too long and complicated to get

there.

RUN

THE PIPE

SPECIALLY CONSTRUCTED

THE STRUCTURAL INTEGRITY OF THE JOIST AND THEREFORE IT

BE AFFECTED

EXISTING PROPERTY OR RENOVATION

The pipe has a 52mm(2") diameter which can be hidden in many natural voids:

The back of a fitted wardrobe

The back of a boiler or airing cupboard

In existing soil pipe boxing

In the loft

Under floorboards

Behind the bath

Underneath kitchen units

Even out side - perhaps next to guttering and painted to match

In the worst case, your installer will either have to complete some boxing-in or you

will have the pipe exposed in the corner of the room behind a door - just paint it the

same colour as the room.

NEW BUILD PROPERTY

Normally all the 52mm(2") pipe will go in at the first-fix stage of the project, so it is

therefore very easy to conceal. The locations shown above are all options, but

obviously with a new build project there are further opportunities to hide the pipe:

In the insulation layer or screed of the floor - just keep the pipe to the edges of the

room, where there is less foot traffic (you will need at least a 55mm depth)

If the project includes underfloor heating around the property, the pipework can

again be located in the insulation.

Utilise the voids within any partition walls - holes can be cut through any noggins

that get in the way when the pipe rises or drops.

T FORGET TO RUN THE WIRE WITH THE PIPE AND LEAVE ENOUGH CURLED UP IN THE

PIPE BEHIND THE PLASTER GUARD TO CONNECT TO THE INLET

WITH

THE JOISTS

(

POSI

JOISTS FOR EXAMPLE WOULD BE ACCEPTABLE

. I

F IN DOUBT

SPEAK TO A BUILDING SURVEYOR OR BUILDER FIRST

NEVER

CUT THROUGH A JOIST UNLESS IT HAS BEEN

). O

S SUPPORT PROPERTIES MAY

SOCKET AT SECOND

THERWISE

FIX