Atlas Donaire Talimatlar Kılavuzu - Sayfa 6
Fan Atlas Donaire için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Atlas Donaire 13 sayfaları. 52” ceiling fan
Sayfayı Yazdır5. HANGING THE FAN
Before touching a screw driver thoroughly
read these instructions.
Warning/Caution: Before installing fan, turn off
power at service panel and check all visible
screws and bolts for tightness.
1. Remove the decorative canopy bottom cover
from the canopy by turning the cover counter
clockwise. (Fig. 5)
2. Remove the hanger bracket from the canopy
by removing the 1 of 2 screws from the
bottom of the hanger bracket and loosening
the other one a half turn from the screw head.
Next, turn the canopy counter clockwise to
removing the hanger bracket from the
canopy. (Fig. 5)
3. Secure the hanger bracket to the ceiling outlet
box using screws and washers included with
your outlet box. (Fig. 6)
4. Loosen the two set screws and remove the
hitch pin and lock pin from the central
shaft/top coupling of the motor assembly.
Doing so will allow the down rod to enter the
central shaft. (Fig. 7)
5. Route wires exiting from the top of the fan
motor through the coupling cover, secure
ring, canopy cover and canopy and then
through the ball/downrod. (Fig. 7)
6. Align the holes at the bottom of the downrod
with the holes in the collar on top of the
motor housing. Carefully insert the hitch pin
through the holes in the collar and downrod.
Be careful not to jam the pin against the
wiring inside the downrod. Insert the lock pin
through the hole near the end of the hitch pin
until it snaps into its locked position. (Fig. 7)
Warning/Caution: Failure to properly install
lock pin as noted in step 6 could result in fan
loosening and possibly falling.
7. Tighten two set screws on top of the fan
motor firmly and fasten the secure ring using
the Allen wranch provided.
8. Place downrod rubber cover onto the hanger
ball.
Electrical
box
Ceiling
hanger
bracket
Mounting screws
(supplied with
electrical box)
Supply wires
Downrod
Secure ring
Coupling
cover
Hitch pin
4
Ceiling
hanger
bracket
Ceiling
canopy
Canopy
cover
Figure 5
Hook
Figure 6
Downrod
rubber cover
Canopy
Canopy cover
Allen wrench
Set screws
Lock pin
Figure 7