Atlas Donaire Talimatlar Kılavuzu - Sayfa 7
Fan Atlas Donaire için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Atlas Donaire 13 sayfaları. 52” ceiling fan
Sayfayı Yazdır9. Now lift the motor assembly into position and
place the hanger ball into the hanger bracket.
Rotate down rod until the "Check Tab" has
dropped into the "Registration Slot" and the
down rod and ball assembly seat firmly. The
down rod and ball assembly should not rotate
if this is done correctly. (Fig. 8)
10. An additional safety support is provided to
prevent the fan from falling. Secure the safety
cable to the ceiling joist with screw and
washer. (Fig. 8)
6. MAKE THE ELECTRIC
CONNECTIONS
Warning: The power should have already been
disconnected. Follow the steps below to connect
the fan to your household wiring. Use the wire
nuts supplied with your fan. Secure the wire
nuts with electrical tape. Make sure there are no
loose strands or connections.
NOTE: The Hand Held Remote Control units
included with your ceiling fan are equipped with
16 code combinations to prevent possible
interference from or to other remote units. The
frequency switches on your Receiver and
Transmitter units have been preset at the
factory. Please re-check to make sure the
switches on both units are set to the same
positions. The frequency settings should be
changed only in case of interference or if a
second or more remote controlled ceiling fans
are installed in the same room. Any code
combination will operate the ceiling fan and light
as long as the Receiver and Transmitter units
are set to the same codes. (Fig. 9)
1. Insert Receiver into Hanger Bracket with the
flat side of the Receiver facing the ceiling. (Fig.
10)
Screw
Safety cable
Registration
slot
Receiver
5
Figure 8
Figure 9
Figure 10
Hanger
bracket