Advanced Racing Computers vLink Kullanıcı Kılavuzu
Fitness Elektroniği Advanced Racing Computers vLink için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Advanced Racing Computers vLink 2 sayfaları. Racing computer
Sayfayı YazdırParts and Assembly sheet for:
Left and right shuttle mounts
Left and right shuttles, w/battery compartments
Two AA batteries – one per shuttle
Diagram A
Final assembly onto skis
Completed
shuttle
assemblies
Step 1:
Install batteries in remote & attach earbuds
•
Remove remote battery cover by lifting thumb tab
and pulling up.
•
Install two AAA batteries, with +/- as indicated
inside battery compartment (Diagram B).
•
Replace remote battery cover, making sure it
closes securely.
•
Thread loop end of lanyard cord through opening;
pull cord end through loop to secure.
•
Press earbud plug securely into port.
Right shuttle and battery compartment
Important Reminder: Remove batteries from shuttles and remote if stored for an extended period of time.
In this package you will find:
Diagram C
Battery compartment
cover
This will avoid damage (from battery leakage) that is not covered under warranty.
The vLink Racing Computer
TM
Left ski and binding
Right ski and binding
Earbud
(audio) port
Lanyard opening
Step 2:
Install batteries in shuttles
•
Using a flat blade screwdriver, remove the two screws in
the shuttle battery compartment cover (Diagram C).
•
Install one AA battery, with +/- as indicated on shuttle
label.
•
Replace shuttle battery compartment cover and tighten
screws, being careful not to cross-thread screws.
•
Repeat with second shuttle.
1 remote unit
Two AAA batteries for remote
1 set earbuds with lanyard
2 alcohol wipes
Assembly Steps
1. Install batteries in remote
2. Install batteries in shuttles
3. Attach shuttle mounts to skis
4. Connect shuttles to shuttle mounts
Important Note:
Please follow instructions carefully. This is a
precision instrument and must be installed
properly to maximize performance.
Diagram B
Remote unit, bottom view
Insert two AAA
batteries as indicated