Advanced Racing Computers vLink Kullanıcı Kılavuzu - Sayfa 2

Fitness Elektroniği Advanced Racing Computers vLink için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Advanced Racing Computers vLink 2 sayfaları. Racing computer

Sayfayı Yazdır

Important Notes About Shuttle Mounts

Mounts are backed with permanent adhesive designed to resist over 5000 lbs. of force. Please follow in-

structions carefully as mounts cannot be reused or repositioned.

Mounts are shaped for 21-meter radius GS skis so that when straight edge of mount is aligned on inside

edge of ski, shuttle lens axis is parallel with ski's centerline. Proper alignment is essential for accurate

carving feedback. To use mounts with other types of skis, be sure straight edge of mount is parallel with

ski centerline, but close enough to inside edge so shuttle body hangs beyond ski surface.

Mounts are designed for skis with a flat upper surface. Skis with grooved centers (e.g. Atomic SL11) require

extra steps for secure installation. See www.advancedracingcomputers.com for more details.

Shuttle mounts are flexible and will not affect performance of skis.

To remove mounts, insert a narrow screwdriver or paint scraper between mount and ski and pry up care-

fully. Replacement mounts can be purchased separately.

Step 3:

Attach shuttle mounts to skis

•

Lay skis on flat surface, bindings up. Skis must be dry and at

room temperature (above 70˚F/21˚C).

•

Take left ski and measure 2" from bottom heel point of boot

binding and pencil mark a horizontal line across ski. Note:

Shuttle body must clear boot binding; allow more than 2" if

needed.

•

Using enclosed alcohol wipe, thoroughly clean ski surface

where mount will be attached; allow surface to air dry.

•

Remove plastic film cover from adhesive on back of left mount.

Mounts are marked L or R, with arrows indicating direction of

tips of skis.

•

Align mount at 2" mark, with straight edge flush with inside

edge of ski (Diagram D). Slowly lower mount onto ski. Press

down firmly (or stand) on mount and hold for several seconds.

Note: A ruler or straight edge held along inside edge of ski can

help with placement.

•

Repeat process with right ski and mount.

•

Let stand for 24 hours at room temperature before inserting

shuttles.

Diagram E

Inserting shuttle into mount

Shuttle release

buttons

Left boot binding

Assembly is complete! Refer to your user's guide for instructions on remote and use of the vLink racing computer.

•

Left shuttle mount

•

Aligning and affixing shuttle mounts onto skis

Align straight edge

of mount to inside

edge of ski

Step 4:

Connect shuttles to shuttle mounts

Align left shuttle (marked with an L) with the left ski and shuttle mount.

Insert one connector end of shuttle into receiving end of mount; snap

other end into place (Diagram E). To remove shuttles, squeeze end buttons

to release.

Test shuttle movement by rotating upward 90 degrees. Note: When

shuttle and mount are attached correctly onto ski, shuttle will not touch

the ground. There should be approximately .12 inches (3 millimeters) of

clearance between bottom surface of shuttle (camera optics) and ground

or snow.

Repeat with right ski and right shuttle mount.

Diagram D

Heel point

of binding

2" clearance mark