Bose PANARAY LT 3202 II Servis Kılavuzu - Sayfa 10

Hoparlör Sistemi Bose PANARAY LT 3202 II için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Bose PANARAY LT 3202 II 18 sayfaları.

Sayfayı Yazdır

DISASSEMBLY/ASSEMBLY PROCEDURES

Note: Numbers in parentheses correspond

to the item call outs in Figure 1.

1. Compression Driver Removal

1.1 Disconnect the Neutrik Speakon™

connector(s) and the weather protector, (if

used).

1.2 Disconnect the red and black wires (6)

from the compression driver terminals.

Note: On some models, the connectors

may have been soldered.

1.3 Remove the four screws (4) holding

the compression driver assembly (3) to the

cabinet.

1.4 Remove the four screws holding the

compression driver (2) to the mounting

plate.

2. Compression Driver Replacement

2.1 Place the new compression driver on

to the mounting plate, and secure it to the

plate.

2.2 Place the compression driver assem-

bly (3) on to the cabinet and secure it to

the cabinet.

Note: Tighten screws in the following

order: clockwise with a torque setting of 5

inch-pounds. Counter clockwise with a

torque setting of 15 inch-pounds. Clock-

wise with a torque setting of 25 inch-

pounds.

2.3 Reconnect the red and black wires (6)

to the terminals on the driver.

2.4 Perform the test procedures on page

13.

2.5 Reconnect the Neutrik Speakon

connector to the speaker panel and re-

place the weather protector, (if used).

3202™/4402™/9702™ SERIES I

3. M-10 Driver Removal

3.1 Perform procedure 1.1.

3.2 Remove the bottom two screws (5) on

the connector panel (7).

3.3 Loosen the two top screws on the

connector panel. This will allow room for

the M-10 driver when lifting it out of the

cabinet.

3.4 Remove the four screws (8) holding

the M-10 driver (1) to the cabinet.

Note: Do not let the driver fall out of the

cabinet.

3.5 Disconnect the green and white wires

(10) from the M-10 driver.

4. M-10 Driver Replacement

4.1 Reconnect the green and white wires

onto the new M-10 driver.

4.2 Place the new M-10 driver (1) onto the

cabinet, carefully routing the green and

white wires around the side of the driver.

4.3 Secure the M-10 driver to the cabinet.

4.4 Replace the two screws (5) in the

bottom of the connector panel, and tighten

all four screws.

4.5 Perform procedure 2.4 and 2.5.

Note: To remove the lower M-10 driver (9)

from the model 3202 simply remove the

four screws (11) holding the driver to the

cabinet, and disconnect the speaker wires.