Bose PANARAY LT 3202 II Servis Kılavuzu - Sayfa 11

Hoparlör Sistemi Bose PANARAY LT 3202 II için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Bose PANARAY LT 3202 II 18 sayfaları.

Sayfayı Yazdır

DISASSEMBLY/ASSEMBLY PROCEDURES

Caution: The rear of the Panaray

loudspeakers can become extremely hot

during normal use. Do not attempt to

service the loudspeakers until they have

cooled to room temperature.

Note: Numbers in parentheses correspond

to the item call outs in Figure 2.

1. Compression Driver Removal

1.1 Disconnect the Neutrik Speakon™

connector from the connector panel (6).

1.2 Remove the two screws (7) holding the

cover assembly on to the cabinet. Slide the

cover assembly (15) up and remove it from

the cabinet.

1.3 Disconnect the red and black wires

from the terminals of the compression

driver (1).

Note: On some models, the connectors

may have been soldered.

1.4 Remove the four screws (4) holding

the compression driver assembly (1) to the

cabinet.

1.5 Remove the compression driver as-

sembly from the cabinet.

1.6 Remove the four screws holding the

compression driver to the mounting plate

(3).

2. Compression Driver Replacement

2.1 Place the new driver on to the mount-

ing plate (3) and secure it to the plate.

2.2 Place the compression driver assembly

(1) into the cabinet and secure it to the

cabinet.

3202™/4402™/9702™ SERIES II

2.3 Reconnect the red and black wires

on the compression driver terminals.

Take care to place the red wire on the

positive(+) terminal and the black wire

on the negative (-) terminal.

2.4 Perform the test procedures on page

13.

2.5 Align the cover assembly (15) tabs

with the slots in the cabinet and slide the

cover into place. Secure the cover to the

cabinet.

2.6 Reconnect the Neutrik Speakon

connector to the connector panel.

3. Vee Four Driver Removal

3.1 Perform steps 1.1 and 1.2.

3.2 Disconnect the green and white wires

from the Vee Four terminals.

3.3 Remove the four screws (5) holding

the Vee Four driver assembly (2) to the

cabinet.

3.4 Remove the Vee Four driver assembly

(2) from the cabinet.

4. Vee Four Driver Replacement

4.1 Place the new Vee Four driver assem-

bly into the cabinet.

4.2 Secure the driver assembly (2) to the

cabinet using the screws supplied with the

new driver assembly package.

4.3 Reconnect the green and white wires

to the terminals on the driver assembly.

Take care to place the green wire on to the

positive (+) terminal and the white wire on

to the negative (-) terminal.

4.4 Perform steps 2.4 thru 2.6.