Bose Aviation Headset X Kullanıcı El Kitabı - Sayfa 15
Kulaklıklar Bose Aviation Headset X için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Bose Aviation Headset X 36 sayfaları. Owner's guide
Ayrıca Bose Aviation Headset X için: Hızlı Kurulum Kılavuzu (1 sayfalar), Kullanıcı El Kitabı (36 sayfalar), Kullanıcı El Kitabı (16 sayfalar), Kullanıcı El Kitabı (36 sayfalar)
Sayfayı Yazdır
Figure 11
Attaching and removing the
cable
Figure 12
Harness connector and
schematic
Getting Your Headset Ready for Use
CAUTION: Do not attempt to pull the connector out without first pull-
ing back on the sleeve. Forcing the connector out will cause damage
to the cable and/or your aircraft instrument panel.
Align keyway
Mounting the connector
Mount the connector into a cutout, as shown in Figure 12 below.
Connect the eight wires as follows:
• Two for the microphone
• Two for audio
• One for power
• One for ground
• Two for audio shields
Audio and microphone wires should be connected to the back of the
existing microphone and headphone jacks, leaving existing jacks
intact for use with conventional headsets. This is usually the fastest
installation method. Also refer to Figures 13-15 on page 18.
12.6mm
.5"
14.1mm
.56"
RECEPTACLE - PINOUT (FRONT VIEW)
PIN 1
PIN 6
AM270261_00 V.pdf May 16 2003
Slide sleeve
to release
AIRCRAFT INTERFACE SCHEMATIC
RED
•
1 V+IN
BLK
•
2 GND
BLK
WHT
•
3 COMM L
BLK
•
4 COMM R
WHT
•
5 MIC HI
WH/BLU
•
6 MIC LO
BLK
15