Droper Field 1000 Kullanım Talimatları Kılavuzu - Sayfa 7

Tıbbi Ekipman Droper Field 1000 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Droper Field 1000 16 sayfaları. Mechanical pressure infuser
Ayrıca Droper Field 1000 için: Kullanım Kılavuzu (15 sayfalar)

Sayfayı Yazdır

2. Infusion line without drip chamber: the operator must therefore use the reverse purge air

drainage technique expelling all air including that contained in the infusion bag and in the

infusion line. If there is no drip chamber, the infused flow must be estimated or checked by

means of a suitable flow regulator.

the operator must maintain pressure on this bag in a backwards direction to prevent it from sliding

forwards when closing the device.

To close: pivot the cover forwards until it enters

into contact with the bulge at the surface of the infusion bag.

Stand directly above the device with outstretched arms and

press down on the cover, placing the cushions of each thumb

on the rough areas located on either side of the cover.

A force of approximately 36 kg is required to pressurise the

device. Prior training is thus recommended to master how to

operate the device.

WARNING: once the movement has been initiated (once the initial resistance has been broken), the

pivoting movement applied to the cover will become easier and the force exerted must be reduced.

This action places pressure on the mobile plate. The resulting significant downwards movement can

be observed. The system closes and is therefore armed as soon as the closing clicks are heard. After

releasing the pressure, the operator must check that the two fastening hooks visible through the

transparent cover are engaged.

If engagement can only be observed on one side, the plate will adopt an inclined position in relation

to the device. In this event, push back down on the cover to release the engaged hook and repeat the

closing operation. This operation pressurises the infusion bag.

2.4

Inserting the infusion bag with the infusion

line and closing the device

Insertion: With the cover fully open, position the

infusion bag on the plate and attach it to one of the fastening

hooks on the plate.

The purpose of these fasteners is to prevent the bag from

sliding forwards when closing the device. Two fasteners are

available according to the model of bag used. Their location is

designed to suit the main infusion bag models available on the

market.

If the fastener does not correspond to the bag model used,

7 / 16