DROTSKY Engineering M100 Operatör El Kitabı - Sayfa 5

Elektrikli Alet DROTSKY Engineering M100 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. DROTSKY Engineering M100 6 sayfaları. Hammer mill

Sayfayı Yazdır

3. START AND USE

Positioning

The machine should be placed on a levelled concrete slab. This will en-

sure that the door which is also the primary shredder can be opened

easily. This will also prevent unnecessary stresses to the door hinges.

Electrical installation

Please consult a qualified individual for electrical installation. The drum

shredder, hammer mill and belt are interlocked so that the drum can-

not start before the hammer mill has been engaged. You have been

supplied with a single starter unit containing a 55kW & 15kW Star

delta and 1.5kW VSD. In the event that the 1.1kW bale conveyor this

will be included as a vsd.(Note that hydraulic model do not contain in-

verters in the starter panel). The overloads on these starters must

be set according to the motor FLC to prevent motor damage in the

event of overloading. Please note that a motor can still sustain dam-

age if started directly after an overheating event. The geared unit on

the belt and bale conveyor have a mounted forced cooling fan. These

fan ensures cooling at low frequency settings. These are may be con-

nected to start with the 55kW.

The rotation directions are as follows: When standing in front of the

hammer mill at the bale inlet chamber your hammer mill rotation

should be clockwise. The drum rotation should be upwards toward the

heavy duty counter bars. The starters must be placed in good view

and proximity of the machine operator. Please allow sufficient cable

length for opening the M100 Door (bale shredder) and 3m bale con-

veyor (If present).

Belt

Inspection

holes