anko FW-45M Kullanıcı Kılavuzu - Sayfa 10

Fan anko FW-45M için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. anko FW-45M 12 sayfaları. Tripod fan

4 Instructions for Use

Remove the cable tie and unravel the cordset before operation.

The fan and motor assembly Can be tilted up and down to your

desired angle.

To adjust the tilt angle, loosen the Tilt Adjustment Knob

(Anticlockwise), tilt the head to the desired angle and then re-

tighten the knob (Clockwise).

Rotate the knob to position I for a low speed, II for a medium speed

and III for a high speed.

Rotate the knob to position 0 to switch the Fan off.

Press the clutch knob down to activate the oscillating function.

The fan head will swing from side to side whilst blowing air.

To stop oscillation, allow the Fan head to move into the desired

position and then pull the clutch knob up.

The height of the fan can be adjusted. Unscrew the adjustment

knob on the side of the Tripod Hub, slide the post up or down to

the desired position then tighten the knob again to lock in place.

Page 10 of 12