anko FW-45M Kullanıcı Kılavuzu - Sayfa 8

Fan anko FW-45M için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. anko FW-45M 12 sayfaları. Tripod fan

3.3 Safety Grille and Fan Blade

To assemble the safety grille and blade assembly, first remove the 4 screws from the

motor assembly and as identified.

Fit the rear safety grille into position (with the handle on the back of the grille at the top)

and refit the 4 screws and tighten.

Remove the protective plastic sleeve from the motor spindle shaft and discard.

Next, rotate the motor spindle until the area with the "flat" surface is facing up.

Slide the fan blade onto the spindle ensuring the screw is lined up with the "flat" surface

on the spindle as shown.

Push on until the end of the spindle is flush with the end of the fan blade hole, then

tighten the screw.

Fan Blade Screw

"Flat" surface on

Motor Spindle

Page 8 of 12

Fan Blade hole flush

with Motor Spindle