Drucker Diagnostics 642B Operatör El Kitabı - Sayfa 7

Teşhis Ekipmanları Drucker Diagnostics 642B için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Drucker Diagnostics 642B 16 sayfaları.

NITIAL

ETUP

If any problems are found during the initial setup procedure, refer to the

troubleshooting section on page 10. For further assistance, contact

Drucker Diagnostics at 814-692-7661.

1. Plug the centrifuge in to an approved electrical outlet. For

electrical safety, the unit must always be properly grounded.

2. Spin the rotor by hand, check for free and level rotation. If the

rotor does not spin freely refer to page 10 on troubleshooting.

3. Place the six test tube holders inside the rotor and verify that

they are seated properly.

4. Close the lid. Rotate the lid knob clockwise to its complete stop

position.

5. Turn the centrifuge on by turning the timer to 10 minutes.

6. The test tube holders will slide up into the horizontal position

and the unit will accelerate to full speed.

7. Listen to the sound of the centrifuge. A smooth whirring sound

should be heard. If there are any loud or unusual sounds, stop

the centrifuge by turning the timer to zero (0).

8. While the machine is running, try to turn the latch

counterclockwise.

9. Power should be cut to the motor

10. If the motor power is not cut when the lid latch is opened,

contact Drucker Diagnostics for assistance

After the centrifuge has passed this procedure, it is ready for operation.

Page | 5 Drucker Diagnostics +1-814-692-7761 - [email protected]

ROCEDURE