Dryflow JJ02 Kullanıcı Kılavuzu - Sayfa 10

Kurutucu Dryflow JJ02 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dryflow JJ02 12 sayfaları. Jet force junior hand dryer

Replace Display Circuit Board

1. Move the sticker away. Do not damage the hand dryer edge as it will affect the surface appearance.

2. Move two screws on timer circuit board holder. Use a screwdriver to pull the holder a little to open it.

3. Take holder out and circuit board will come together. Be careful of the connection wire.

4. Move two screws on circuit board and replace a new one.

5. Replacing new circuit board. It is suggested to use a new sticker for best appearance.

Open Hand Dryer Front Cover

1. Loosen 4 front cover screws on hand dryer back base as the arrow marked.

2. Loosen 2 front cover screws on the hand dryer front & bottom.

3. Pull the front cover up then back a little to take it.

4. Pull the cover slowly and slightly because there are plastic locks on the top side.

5. DO NOT damage the top side plastic locks because they are used to fix the front cover on

the base.

4 front

cover screw

2 front cover screw

Display circuit board

Plastic locks