Dryflow JJ02 Kullanıcı Kılavuzu - Sayfa 11

Kurutucu Dryflow JJ02 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dryflow JJ02 12 sayfaları. Jet force junior hand dryer

Replace Main Circuit Board, Sensor Receiver Board, Motor, Heat Element

Main Circuit Board: Move marked circuit board house cover and replace a new circuit board.

Sensor Receiver circuit board: Move marked circuit board screw and replace a new one.

Replace Heat Element:

1. Move marked air hole cover.Take the heat element out then replace a new one.

2. Replace air hole cover. Be sure the air seal rubber at right location to avoid air leakage.

Replace Motor:

1. Move marked air hole cover and motor cover. Take the motor out and then replace a new motor.

2. Replace motor cover. Be sure the motor protection rubber & foam, air seal rubber at right location.

3. Replace air hole cover. Be sure the air seal rubber at right location to avoid air leakage.

Sensor Receiver

Circuit Board

Air hole cover

Heat element house

Main circuit

board house

Periodic cleaning of the unit is recommended. Remove cover and clean dryer dust lint.

Stainless steel is highly resistant to rust, but there are some very strict cleaning and

maintenance rules to be followed to prevent damage to its appearance.

Apply neutral detergents formulated for these purposes (non-ionic surfactants and citric

acid). Apply the detergent with soft cloth. Be careful with abrasive cloths. They may

scratch the surface. Rinse with water until all the detergent has gone.

Residue from hygiene products, liquid soap, shampoos, bath gel, etc, can also damage

surfaces. Rinse the surface with plenty of water after use.

Limescale stains can be prevented by drying the surface with a soft cloth after use.

Main Circuit Board

Motor house

Heat element

Motor