3M Dynapro ET 3170 Terminal Series B Kurulum Kılavuzu
Monitör 3M Dynapro ET 3170 Terminal Series B için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. 3M Dynapro ET 3170 Terminal Series B 2 sayfaları. Desktop stand's installation: terminal and computers
Ayrıca 3M Dynapro ET 3170 Terminal Series B için: Kurulum Kılavuzu (4 sayfalar), Kurulum Kılavuzu (3 sayfalar), Kurulum Kılavuzu (4 sayfalar), Kurulum Kılavuzu (6 sayfalar)
Sayfayı Yazdır
Installing the Desktop Stand
ET 3170 Terminal and ET 3210/3215 Computers
Intended Use
When properly installed using the materials provided, and
according to these instructions, the two-piece desktop stand
is intended to mount the ET 3170 terminal and the ET 3210
and ET 3215 computers for use on a desktop or other flat
surface.
Product safety information
Read and understand all safety information in this
document before installing and using the desktop stand.
WARNING
To reduce the risks associated with electric shock or fire
which, if not avoided, may result in death or serious injury
and/or property damage:
Follow all product and accessory installation instructions.
!
CAUTION
To reduce the risks associated with the unit tipping over,
which may result in minor or moderate injury and/or cause
property damage:
Do not open the bezel of the ET unit while it is mounted on the
!
desktop stand.
Equipment
Materials supplied
1 vertical stand assembly
!
1 detachable base with feet
!
4 #10-32 x 3/8-inch Phillips screws
!
4 plastic screw knobs
!
Mounting steps
The desktop stand has a vertical stand and a detachable
base with feet. To install the desktop stand to the terminal
or computer, follow these steps:
3M Touch Systems Proprietary Information
1
1. Place foam pads or other material on a flat surface.
2. Lay the ET unit face down on the protected surface
while installing the desktop stand.
3. Fit the stand around the lower edge of the back of the
unit.
4. Using a No. 2 Phillips screwdriver, attach the stand to
the unit with the four screws provided to a torque of
15 inch-pounds.
5. Attach the base to the upright section of the stand with
the four plastic screw knobs supplied.
72062