Anslut 016990 Kullanım Talimatları Kılavuzu - Sayfa 11

Fener Anslut 016990 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Anslut 016990 12 sayfaları. Bulkhead luminaire

Sayfayı Yazdır

INSTALLATION

IMPORTANT:
Disconnect the power supply before installation.
1.
Pull the power supply wires through the
entry in the base of the product.
2.
Insert the wires in the supplied protective
tubes. Make sure the protective tubes
completely cover the wires to the
bulb socket, from the safety ring to the
safety plate on the socket.
3.
Connect the wires to the socket.
The casing must be connected to earth.
4.
Mount the base in the required place with
expansion plugs and screws.
5.
Insert a bulb with no more than the
maximum output specified for the
product.
6.
Fit the glass cover and the guard on the
base with the screws.

MAINTENANCE

NOTE:
•
When the product is switched on the
bulb gets very hot. Switch off the bulb
and allow it to cool before touching it.
•
Switch off the power supply before

replacing the light source.

REPLACING THE LIGHT SOURCE
IMPORTANT:
Switch off the power supply before replacing
the light source.
1.
Remove the protective grille and glass cover.
2.
Carefully unscrew the cool bulb.
3.
Check that the new bulb is clean and
screw it in place in the socket.
4.
Replace the protective grille and glass
cover before switching on the product.
CLEANING
IMPORTANT:
Switch off the power supply before cleaning.
1.
Switch off the power supply to the light.
2.
Wipe the light with a dry or slightly damp
cloth.
3.
Wait until the light is completely dry
before switching the power supply on
again.
NOTE:
Do not use detergents, alcohol, solvents or
the equivalent to clean.
EN
11