DSC PowerSeries Kullanıcı Kılavuzu - Sayfa 12

Kontrol Ünitesi DSC PowerSeries için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. DSC PowerSeries 20 sayfaları. Telephone interface & automation control module
Ayrıca DSC PowerSeries için: Ürün Özet Sayfası (20 sayfalar)

Sayfayı Yazdır

Bell Squawk Attribute

This attribute is used to determine whether an access code should generate an arming/disarming Bell

Squawk upon entry of the code for Away arming. The Wireless Keys with access codes associated

with them may generate Arming/Disarming Bell squawks. Contact your installer to have this

programmed.

NOTE: The Master Code cannot use the Bell Squawk attribute, but is required to enable it for other

codes.

NOTE: This feature cannot prevent the Arm/Disarming squawks from being generated if an access

code assigned to a WLS Key is manually entered at a keypad.

Erasing an Access Code

To erase a code, select the code and enter

delete the code immediately and the user will be returned to select another code.

User Function Commands

First disarm the system then enter

The

command is used to gain access to the following list of Master functions of the system.

[1] Time and Date

Enter 4 digits for 24 Hour System Time (HH-MM). Valid entries are 00-23 for the hour and 00-59 for

minutes. Enter 6 digits for the Month, Day and Year (MM-DD-YY)

[2]-[3] Future Use

[4] System Test

The system's Bell Output - 4 seconds (2 seconds medium volume, 2 seconds high volume ), Keypad

Lights, Back up Battery Pack and Communicator are tested.

[5] Enable DLS / Allow Remote System Service

If enabled, the installer will be able to access Installer Programming remotely using DLS (Downloading

Software). This function provides a window for telephone ring detection by the alarm system. The DLS

window will remain open for 6hrs, during which time the installer will be able to enter DLS an unlimited

number of times. After the 6-hr. window has expired, access to programming via DLS will be unavailable

until the window is re-opened.

[6] User Call-up

If enabled by the Installer, the panel will make 1 attempt to call the downloading computer. The

downloading computer must be waiting for the panel to call before downloading can be performed.

[7] For Future Use

[8] User Walk Test

Allows the user to enter the Walk Test mode. See Walk Test on page 9.

Changing Brightness/Contrast

When this option is selected, the keypad will allow you to scroll through 4 brightness levels and 10

contrast levels.

1. Press

[Master code].

2. Use the

3. Press

to select the setting you want to adjust.

4. a) 'Brightness Control': There are 4 backlighting levels. Use the

level.

b) 'Contrast Control': There are 10 different display contrast levels. Use the

to the desired contrast level.

5. To exit, press

Changing the Buzzer Level

When this option is selected, the keypad will allow you to scroll through 21 different buzzer levels. A

level of 00 disables the buzzer.

1. Press

[Master Code].

[Master Code]

keys to scroll to either Brightness Control or Contrast Control.

as the first digit. If

is entered, the system will

keys to scroll to the desired

keys to scroll