DT SWISS 240 OVERSIZE Teknik Kılavuz - Sayfa 12

Bisiklet Aksesuarları DT SWISS 240 OVERSIZE için çevrimiçi göz atın veya pdf Teknik Kılavuz indirin. DT SWISS 240 OVERSIZE 14 sayfaları.

14. Check the bearing.

→ The hub must turn smoothly.

→ The hub must not have axial play.

15. If necessary, drive in the bearing on the non drive

side or loosen the bearing.

16. Repeat previous steps until the hub is turning

smoothly.

3.7 PUTTING ON THE END CAPS

1. Grease the bearings and the inner surface of both

end caps.

2. Screw on both end caps by hand.

3. Tighten the end caps with a suitable tool to 15

Nm.

→ 20 mm, 15 mm and 9 mm end caps: 22 mm

wrench

→ QR end caps: 5 mm hex key

Closing Steps:

Mount the brake rotor

Link