AIRTRONICS SD-10G Aero Hızlı Başlangıç Kılavuzu - Sayfa 4
Uzaktan Kumanda AIRTRONICS SD-10G Aero için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. AIRTRONICS SD-10G Aero 5 sayfaları. 2.4ghz fhss-3 radio control system
Ayrıca AIRTRONICS SD-10G Aero için: Hızlı Kurulum Kılavuzu (8 sayfalar), Manuel (16 sayfalar)
Sayfayı Yazdır
Use the Navigation Pad to select MIXING. Press the ENTER key.
Select FLAPERON –Press ENTER key. Flight Mode 4 Switch (#22) is still ON.
Use the YES/+ key and NO/- Keys to make the Flaperon Mix read as follow
Scroll down to FL>EL --Press ENTER key.
Use the YES/+ key and NO/- keys to make Flap to Elevator Compensation Mix read as follows:
Select SURFACE using the Navigation Pad. Press ENTER.
Press the Navigation Pad Down arrow and select EPA. Scroll to the right and select LF.
Use the Yes/+ key to input a value of 100%. Do the same for the RF
The screen will show 2 100% indicating FLAP 2 is used for this function. Note that polarity determines
the direction of the Flap servo throw and value the amount....Press the END key twice.
Note: Turn OFF each Flight Mode switch after completion of each of the Flight Mode mixes. The above
figures are trial values. Fine tune later. The value determines the amount of servo travel and the polarity
determines the direction of servo travel.
- 4 -
F-MODE (4)
COMMON >SEP
ACT/INH > ACT
FL >LA 100%
FL >RA 100%
Press END key.
F-MODE (4)
COMMON > SEP
FL > EL > + or – 10% Press END key three times.
Jack R. Albrecht
Airtronics Technical Support
17 June 2009