Auber Instruments TD120-W Kullanım Kılavuzu - Sayfa 4

Sıcaklık Kontrolörü Auber Instruments TD120-W için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Auber Instruments TD120-W 4 sayfaları. Wireless temperature controller
Ayrıca Auber Instruments TD120-W için: Tamamlayıcı Kılavuz (2 sayfalar)

Sayfayı Yazdır

AUBER INSTRUMENTS

2. There are two Set Points -- CSP and HSP. Each Set Point has its

own output relay, Cooling Relay and Heating Relay. Each Set Point

has a control differential value, CdF or HdF.

3. In the Reverse Logic mode, user can choose to use either the

Cooling Relay (output socket on the left) or the Heating Relay (output

socket on the right) to drive an external load.

4. In the Reverse Logic mode, the relay will be energized when the

probe reading is within the temperature range set by CSP (75° F) and

HSP (32° F) as well as their differential bands CdF and HdF.

Note 8. rST is the factory reset parameter. Choose "Yes" to reset all

the parameters back to factory settings.

Note 9. PSd is the device access password (only available to TD120-

W model). This parameter is used to lock the access to parameter

settings on Aubersmart App.

7. How to install the sensor to the unit.

The connector of sensor contains a slot for fitting pin connection. It also

has a spring lock to prevent disconnections from accidental pulling on

the cable. To install the sensor to the controller: 1) identify the key on

the male connector (Figure 5, a) and the notch on the female connector

(Figure 5, b); 2) hold the tail of the female connector, align the notch

and the key, and push the female connector forward (Figure 5, c). To

remove the connector, hold the spring-loaded collar on the female

connector and pull it back. Please see Figure 6.

2019.08

(a)

(b)

No part of this manual shall be copied, reproduced, or transmitted in any way

without the prior, written consent of Auber Instruments. Auber Instruments

retains the exclusive rights to all information included in this document.

WWW.AUBERINS.COM

Figure 5. Install the sensor.

Figure 6. Remove the sensor.

Auber Instruments Inc.

5755 North Point Parkway, Suite 99,

Alpharetta, GA 30022

www.auberins.com

E-mail: [email protected] Tel: 770-569-8420

(c)

P4/4