AIRTRONICS RDS8000 FHSS Manuel

Oyuncak AIRTRONICS RDS8000 FHSS için çevrimiçi göz atın veya pdf Manuel indirin. AIRTRONICS RDS8000 FHSS 7 sayfaları.

The purpose of this guide is to assist new helicopter pilots to setup their radio. Many basics will be

covered, as well as explanations of certain choices and how one aspect affects another. Experienced

pilots may want to skim through this guide. It first covers the preliminary transmitter programming

steps, then swash plate, tail rotor, and throttle / pitch / revolutionmixing curves. Finally, it briefly covers

the available compensation mixers, and optional use of the 7

and 8

channels. (Not applicable to

RD6000 owners.)

While some helicopter setup theory is

covered, the instructions from the

manufacturer of your particular helicopter

override any suggestions offered here. In the

case of doubt, please contact your helicopter

manufacturer or Airtronics customer

service.

If you are setting up an electric helicopter,

ensure that your motor is disconnected from

the speed control while making any

adjustments. Do not have your engine

running while making adjustments if you

have a glow or gasoline model.

Preliminary Transmitter Setup

Power on your transmitter. It will not operate however, until it is placed into the Normal ("N") flight

mode, with the throttle stick at the lowest position. If those conditions are not met, you will see an ID

UP! or THHi! warning message and hear beeping. The two switches at the far upper left and right

sides of your transmitter control the flight modes. Both must be positioned toward you to enter the

Normal flight mode.

Select a model memory to use for your helicopter. Navigate to ETC > MSL, then press the

Inc+/Yes

button to enter that menu. Now use the

buttons to scroll through your model

Inc+/Yes

Dec-/No

memories. After selecting the desired model memory, press the

key to confirm.

End

Ensure that your model memory is set to "heli" mode. The upper left corner of your screen will say

either "heli" or "aero." If it lists "aero", switch to helicopter mode by navigating to ETC > TYP, press

the

key, then the

key to confirm the change. Finally press the

key to return to the

right arrow

Inc+/Yes

End

previous menu.