AIRTRONICS RDS8000 FHSS Manuel - Sayfa 3

Oyuncak AIRTRONICS RDS8000 FHSS için çevrimiçi göz atın veya pdf Manuel indirin. AIRTRONICS RDS8000 FHSS 7 sayfaları.

There is one exception for the swash plate type that we are aware of. The Thunder

Tiger Mini Titan helicopter has a unique system that results in negative collective pitch

being applied when the swash plate is raised. For that reason, if you have the Mini

Titan you will need to use the CP3F option, and attach your front servo to the Ch1

"Elevator" slot, your rearleft servo to the Ch2 "Aileron" slot, and your rearright servo

to the Ch6 "Pitch" slot.

While the diagram above lists the CCPM servos as "elevator" "aileron" and "pitch" they do not actually

perform those functions because they work in unison. Regardless, when programming servospecific

options in your radio, the servos will be identified that way.

If you have not already done so, make sure your rotor head linkages are setup correctly. Consult your

helicopter's manual for details. For your convenience, a brief summary of typical rotorhead setup is

listed below.

With a collectivepitch helicopter, it is crucial that all of your linkages are setup

correctly and safely. A linkage of the incorrect length will result in differential and

exponential throw, and if the link is assembled incorrectly it can come apart in flight.

Ensure that your rods thread into the plastic links securely, and more than just a few

threads are holding it together.

With your throttle/collective stick centered your swash plate servo arms should be at 90

degrees to the linkages, the swash plate should be level, the paddles should be level, the

washout / mixer / flybar arms should be level, and your main blades should have zero

degrees pitch. Adjust your linkages as needed to achieve this.

When your throttle / collective stick is centered, the swash plate should be very close to level. When you

give an input with the cyclic stick, the swash plate will most likely not respond as expected because

servo reversing and end points have not been set.

Adjust servo reversing by navigating to EL > REV, then use the

between NOR and REV to change the "elevator" servo direction. Use the left and right

scroll to the other channels ("aileron" and "pitch.") Make the adjustments as needed so that your swash

plate tilts correctly. When you move the cyclic stick forward, the swash should tilt forward. When you

move the cyclic stick to the left, the swash should tilt to the left, etc.

keys to toggle

Inc+/Yes

Dec-/No

keys to

arrow