Anybus Communicator CAN PROFINET IRT 2.32 Ağ Kılavuzu - Sayfa 10

Sunucu Anybus Communicator CAN PROFINET IRT 2.32 için çevrimiçi göz atın veya pdf Ağ Kılavuzu indirin. Anybus Communicator CAN PROFINET IRT 2.32 20 sayfaları. Interface
Ayrıca Anybus Communicator CAN PROFINET IRT 2.32 için: Kurulum Kılavuzu (2 sayfalar)

Sayfayı Yazdır

Network Configuration

To be able to communicate over Ethernet the network interface needs a valid TCP/IP configura-

tion. This section explains some basic concepts in TCP/IP networking and describes how to

configure the TCP/IP settings in the Anybus X-gateway PROFINET IRT (2.32) interface using

the IPconfig software tool.

When Ethernet communication has been established the TCP/IP settings can also be changed

from the web interface. See

4.1

Basic TCP/IP Concepts

IP Address

The IP address is used to identify each node on a TCP/IP network. IP addresses are written as

four decimal integers (0–255) separated by dots, where each integer represents the binary val-

ue of one byte of the IP address. This is known as dot-decimal notation.

Example: 10000000 00001010 00000010 00011110 is written as 128.10.2.30

The following IP addresses are reserved for special purposes and cannot be used:

0.n.n.n

127.n.n.n

n.n.n.0

n.n.n.255

Subnet Mask

The IP address is divided into three parts: Net ID, Subnet ID and Host ID. A subnet mask is a

32-bit binary pattern, where a set bit allocates a bit for Network/Subnet ID, and a cleared bit al-

locates a bit for the Host ID. The subnet mask is usually written in dot-decimal notation.

Example: To make the IP address 128.10.2.30 belong to subnet 128.10.2, the subnet

mask must be 255.255.255.0.

Subnet mask:

Default Gateway

For devices to be able to communicate over Ethernet they must either belong to the same sub-

net or communicate via a gateway or router.

A gateway or router routes communication between networks, i.e. it enables the nodes on one

network to access the nodes on another. The default gateway address in the TCP/IP settings of

your product specifies the IP address of the gateway or router on the local network.

Anybus

X-gateway

™

PROFINET

Web Pages, p.

First byte zero — used for broadcast messages

First byte 127 — used for loopback addresses to the local host

Last byte zero — identifies a whole network/subnet

Last byte 255 — used for broadcast messages

11111111 11111111 11111111 00000000 (255.255.255.0)

Net ID / Subnet ID

IRT (2.32) Interface Network Guide

12.

Host ID

8 (18)

SCM-1202-028-EN 1.1