AnyDATA ACT233F Kullanıcı Kılavuzu - Sayfa 11

GPS AnyDATA ACT233F için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AnyDATA ACT233F 14 sayfaları. 4g vehicle tracker with hotspot

4G V

HANDING THE

4.1 S

1. Most of vehicle has an OBD-II (On Board Diagnostics) connector, which

is located within 2 feet of the steering wheel.

2. The installation is very easy, just put the ACT233F to the OBD-II

connector in user vehicle.

3. The ACT233F will power on automatically from vehicle battery and

start initiation for CDMA or LTE network access.

4. After install of device to vehicle, all services are served by server.

Figure 4.1: Installation of ACT233F in vehicle

4.2 P

OWER SUPPLY FROM VEHICLE

1. After insertion of ACT233F to OBD-II connector, the device has

automatically power-on with the car battery, typically 9~18V.

2. If the engine has off, then the device decide to power off the OBD

interface circuit, and run the CDMA/LTE RF with GPS for the

unauthorized movement function.

If the engine has on, then the device work on the OBD interface

circuit, which is charge of gathering the vehicle information such

as fuel gauge, speed, engine RMP, and so on to report it to LBS

server via the CDMA or LTE network.

4G Vehicle Tracker with Hotspot user Manual (ACT233F)

EHICLE

RACKER WITH

(

13.5V)

TYPICAL

OTSPOT

11/13