Dulytek DW4000 Kullanım Kılavuzu - Sayfa 12

Elektrikli Alet Dulytek DW4000 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Dulytek DW4000 13 sayfaları. Heat press

INSTRUCTION MANUAL: DW4000

OPERATING INSTRUCTIONS

TURNING OFF

THE PRESS

CALIBRATING

TEMPERATURE

CONTROLS

(optional)

Dulytek Equipment

www.dulytek.com

1. Turn off the press machine by flipping ON/OFF switch when done

pressing.

2. Unplug and then disconnect the AC power cord from the press.

3. Wait until the press cools down completely to store it.

Calibrating a control panel should be done if the actual temperature shown

on its screen deviates from the set temperature after heating is done. Please

follow the steps below to calibrate and proof-read the affected temperature

control:

1. Press DOWN button for 5 seconds to enter into Temperature Collation

mode (Figure 13). The ON LED indicator will light up (Figure 14).

2. Wait for approximately 4 to 5 minutes. The temperature control will re-

calibrate itself and adjust to the set values (Figure 15).

Figure 13

(continued)

Figure 14

Figure 15

PAGE 11