Dulytek DW4000 Інструкція з експлуатації - Сторінка 12
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Dulytek DW4000. Dulytek DW4000 13 сторінок. Heat press
Друкувати сторінкуINSTRUCTION MANUAL: DW4000
OPERATING INSTRUCTIONS
TURNING OFF
THE PRESS
CALIBRATING
TEMPERATURE
CONTROLS
(optional)
Dulytek Equipment
www.dulytek.com
1. Turn off the press machine by flipping ON/OFF switch when done
pressing.
2. Unplug and then disconnect the AC power cord from the press.
3. Wait until the press cools down completely to store it.
Calibrating a control panel should be done if the actual temperature shown
on its screen deviates from the set temperature after heating is done. Please
follow the steps below to calibrate and proof-read the affected temperature
control:
1. Press DOWN button for 5 seconds to enter into Temperature Collation
mode (Figure 13). The ON LED indicator will light up (Figure 14).
2. Wait for approximately 4 to 5 minutes. The temperature control will re-
calibrate itself and adjust to the set values (Figure 15).
Figure 13
Email: [email protected]
(continued)
Figure 14
M
Figure 15
© 2018 Dulytek
All rights reserved
PAGE 11