Dumor EASYBINDER 80 Kullanıcı Kılavuzu - Sayfa 4

Ciltleme Makinesi Dumor EASYBINDER 80 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dumor EASYBINDER 80 10 sayfaları.

Sayfayı Yazdır

Registration

(10d)

The machine runs centred, there is a red arrow on the glue tank indicating the centre line for the cover.

First cycle

The machine is now ready to use in book mode.

Press the start button

(19)

(15a)

(if in use), over the spine rollers (15b), and

The paper clamp will move to the right, over the milling head, past the side gluing rollers

(10)

will stop over the cover press.

The cover press will rise and nip the cover onto the under-hanging part of the book block that had been milled and glued.

The pressing will be timed according to the preset value and will then release( usually set at 5 sec ).

The paper clamp will then open after the pre set holding time (usually 4 sec) and the book can be slid out on the right side and stacked

vertically until fully dry.

The clamp will return back to the left start position.

The process can be repeated again.

Block mode

The machine can be used to glue blocks either with or without milling.

In the user menu choose the block mode.

The cover pressing will be inhibited.

We suggest to not use the milling as it will splay open the paper.

Great care needs to be take when sliding the block out as the spine glue will still not be fully hard and will stick to the cover press if the

block is lowered.

User adjustments

Paper clamp opening amount

(11c)

The degree of opening can be set by moving the stop pin

(early models) and / or via the control panel setting for the opening.

Milling height can only be re set by a technician, the adjustment is minute.

Side gluing enabled (inwards) normal setting.

The side gluing is self setting according to the book block thickness.

Side gluing disabled (outwards) optional setting if you hold it open using 2 pins (15c), for example when gluing blocks with no cover.

Glue tank height

The glue tank can be raised or lowered by the screw under the tank, the adjustment is minute, is factory set and should not be altered.

Glue scraper height

(15d)

The height of the glue scraper can be altered by a qualified technician only the adjustment is minute.

Spine glue cut off settings left and right

To avoid glue over-spill at the end of the spine.

(11d) (11e)

There are 2 knobs on the paper clamp located in slots.

These move a "ski "that will act on the glue cut off flap to close it.

(11f)

The glue cut off can be adjusted inwards and outwards, there is a mm scale on the slots.

Clamp side pressing force

(10e)

Can be set via the control panel we recommend setting 7 to 8