Danfoss DEVIreg 233 Kurulum Kılavuzu - Sayfa 7

Termostat Danfoss DEVIreg 233 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Danfoss DEVIreg 233 12 sayfaları.

DEVIreg™ 233

3. Mount and reassemble the thermostat. The thermo-

stat is to be installed in a flush-mounting box or a

surface-mounting box for the FUGA design.

• Put the unit back in place and tighten the screws in

each side to fasten the thermostat.

• Press the front cover back in place.

4. Turn on the power supply.

Settings

Please be aware of the following:

• The floor temperature is measured where the sen-

sor is placed.

• The temperature of the bottom of a wooden floor

can be up to 10 degrees higher than the top.

• Floor manufactures often specify the max tem-

perature on the top surface of the floor (usually

27-28˚C).

• Always use a floor sensor to control floor heating.

Installation Guide