Danfoss TP7000 Series Kullanıcı Kılavuzu - Sayfa 8
Termostat Danfoss TP7000 Series için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Danfoss TP7000 Series 11 sayfaları. Electronic programmable room thermostat
Ayrıca Danfoss TP7000 Series için: Kurulum Talimatları Kılavuzu (9 sayfalar), Kurulum Talimatları Kullanıcı Talimatları (14 sayfalar)
Sayfayı Yazdır
1.8 Before you change the preset programmes
Your installer will have set your unit to operate in either 7-day mode
or 5/2 day mode. To tell which mode your unit is set press PROG
until Event 1 fl ashes in the display.
1
GB
F
1 2 3 4 5
D
1.81 Programming in 7-day mode
(separate programmes for each day of the week)
ES
a) Press PROG until Event 1 fl ashes, then
DK
press DAY to move from current day to
Day 1.
NL
I
GR
b) Amend the time and temperature as
follows:
PL
i)
Use + and – buttons to alter time
(press and hold to change in 10 min
increments).
LT
ii)
Use
CZ
temperature in 0.5°C (1°F) steps.
iii) Press NEXT to advance to next
HR
Event.
iv) Repeat steps i,ii & iii above for Events
2, 3, 4, 5 & 6.
c) When all 6 events are correct, press DAY
to programme events for Day 2.
8
This unit is in 7-day mode and you can programme
diff erent settings for each day of the week (see page
8-9).
This unit is in 5/2 day mode and you can enter one of
set of programmes for weekdays and another set for
weekends (see page 91).
and
buttons to alter
1
TP7000 RANGE