3Ware 9000 Series Sürüm Notları - Sayfa 5

Kontrolör 3Ware 9000 Series için çevrimiçi göz atın veya pdf Sürüm Notları indirin. 3Ware 9000 Series 9 sayfaları. Serial ata raid controller release 9.2.0
Ayrıca 3Ware 9000 Series için: Şartname (2 sayfalar)

Sayfayı Yazdır

5. Type:

chkconfig --add --level 345 3dm2

6. Change the operating mode by typing:

chmod +x /etc/rc.d/init.d/3dm2

7. Change the permissions on the 3dm2 configuration file:

chmod 600 /etc/3dm2/3dm2.conf

8. Start the 3DM 2 daemon by typing:

/etc/rc.d/init.d/3dm2 start

9. Open the web browser and go to https://localhost:888 or http://localhost:888.

Fedora Core 3 – 3DM 2 crashes when email notification is used

If you use email notification (using sendmail or any other email server) under

Fedora Core 3, the 3DM 2 daemon will crash. You will then have to restart the

3DM 2 daemon (e.g.

problem, you must use the IP address instead of the name in the 'Server (name or

IP)' box to resolve this issue. You can use 127.0.0.1 by default or the actual IP

address of your server.

If you don't know the IP address of your mail server, you can get it by typing:

nslookup <your email server name>

See 3ware KB article 12753

Linux (all versions) - After Migration Additional Steps are Required to Show & Use New

Capacity

To get the new unit capacity to show up on the block device target within Linux,

after the migrate completes, do the following:

If the newly migrated unit is being used as primary storage, then a reboot is

required before seeing the new unit size. Following the reboot proceed to step-4.

If the newly migrated unit is being used as secondary storage, do the following:

1. Unmount all filesystems, swap devices, and stop all processes which have open

file descriptors on the unit that had its capacity expanded

2. Use 3DM 2 or tw_cli to remove the newly migrated unit

720-0123-00 Rev. A

/etc/rc.d/init.d/3dm2 start

http://www.3ware.com/kb/article.aspx?id=12753

). To get around this