3Ware 9000 Series Sürüm Notları - Sayfa 7

Kontrolör 3Ware 9000 Series için çevrimiçi göz atın veya pdf Sürüm Notları indirin. 3Ware 9000 Series 9 sayfaları. Serial ata raid controller release 9.2.0
Ayrıca 3Ware 9000 Series için: Şartname (2 sayfalar)

Sayfayı Yazdır

3DM 2 remote access requires synchronized time

When accessing a computer remotely with 3DM 2, the system time on the remote

computer cannot vary by more than 30 minutes (including time changes due to time

zones) from the system with the 3ware controller. You will be allowed to connect

remotely, but if you click on any screen you will get the message: "

You have been logged out due to inactivity or Cookies are disabled"

connect to a system, change the local time of remote system to match the time of

the system with the 3ware controller. See 3ware KB article 13322.

http://www.3ware.com/kb/article.aspx?id=13322

Linux/FreeBSD - 3DM2 Daemon Startup

If the 3DM 2 daemon was started when the 3ware driver was loaded, you will have

to stop and restart the daemon:

e.g. /etc/rc.d/init.d/3dm stop

/etc/rc.d/init.d/3dm start

Fedora Core 3 / AMD 64-bit – can't update the mkinitrd file

When installing Fedora Core 3 (64-bit version) to a 3ware RAID array as primary storage,

by default FC3 uses LVM when creating the disk partitions. If you use LVM, then you will

not be able to update the 3ware driver at a later time. Updating the 3ware driver at a later

time with the mkinitrd command will cause the system to not be able to boot. See 3ware

KB article 13297

http://www.3ware.com/kb/article.aspx?id=13297.

SODIMM Memory Module

Use only the memory that is included with the controller or one that is listed in the

compatibility chart posted in the product knowledge base.

http://www.3ware.com/kb/article.aspx?id=11748

3DM 2 Schedule/Verify Behavior

In cases when no time slot task (verify/schedule) is scheduled 3DM displays "Disabled

until at least one scheduled entry is set below." When the user schedules a new task the

system automatically sets "Ignore" for the requested scheduled.

3DM 2/CLI Array Naming

The following characters are not allowed for array names, including a space:

@ % & , ; : " ' { } | \ ~ ` * [ ] < > ( )

For Controllers using the Battery Backup Unit (BBU)

• BIOS reports "Error 01D2 in opcode 13. Press any key to continue" This message

will appear when creating an array with cache enabled and the BBU is not read (e.g.

in testing or charging mode). Create arrays before starting any BBU tests, or create

the arrays with cache disabled.

• The battery is defective and should be replaced if either the

HIGH_CURRENT_TEST_WARNING or HIGH_CURRENT_TEST_FAULT

messages are reported by the controller. When the battery is in this status, it may

720-0123-00 Rev. A

(0x0C:0x001A):

To remotely