Dunster House Artemis P3-3050PRG Kurulum Kılavuzu - Sayfa 13
Barınaklar Dunster House Artemis P3-3050PRG için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Dunster House Artemis P3-3050PRG 17 sayfaları. Pergola 3m x 5m
Sayfayı YazdırAssembly Instructions for Additional Wall Panels for Artemis Pergola
Components required - quantities vary depending on your purchase
Panel CP1
Step 1.
Position the panels between the support posts as shown in the diagram below. Join the panels to each other and
the support posts using 5x 60mm screws per panel side. You will also need to screw through the panels and up into the
'140x45' horizontal purlins using 2x 60mm screws per panel.
60mm Screws
(2 per panel)
Panel CP1
Panel CP10
145
Panel CP10
**Full height wall panels assembly**
90
60mm Screws
2990
2700
30
Panel CP1
60mm Screws
145
Fix the panels into the concrete
base by measuring and drilling
16x70mm deep holes (2 per
panel) and inserting the shield
anchors into the holes. Fix the
panel by using the M10x110mm
bolts and M10 washers and
tighten.
M10x110mm
bolt & washer
M10 shield anchor
(M16x80 deep
hole required)
Concrete
60mm Screws
M10x110mm Bolts
M10 Shield Anchors
M10x28mm Washers
View from inside
Panel
Page 03