Dunster House Artemis P3-3050PRG Kurulum Kılavuzu - Sayfa 15
Barınaklar Dunster House Artemis P3-3050PRG için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Dunster House Artemis P3-3050PRG 17 sayfaları. Pergola 3m x 5m
Sayfayı YazdırAssembly Instructions for Additional Wall Panels for Artemis pergola
Components required - quantities vary depending on your purchase
Panel CP2
Step 1.
Position the panels between the support posts as shown in the diagram below. Join the panels to each other and
the support posts using 3x 60mm screws per panel side.
Panel CP10
145
Panel CP10
**Half height wall panels assembly**
Panel CP2
90
60mm Screws
2990
2700
30
60mm Screws
M10x110mm Bolts
M10 Shield Anchors
M10x28mm Washers
View from inside
Panel CP2
60mm Screws
145
Fix the panels into the concrete
base by measuring and drilling
16x70mm deep holes (2 per
panel) and inserting the shield
anchors into the holes. Fix the
panel by using the M10x110mm
bolts and M10 washers and
tighten.
M10x110mm
bolt & washer
M10 shield anchor
(M16x80 deep
hole required)
Concrete
Panel
Page 05