Free The Tone CW-1Y Kullanıcı El Kitabı - Sayfa 8
Müzik Pedalı Free The Tone CW-1Y için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Free The Tone CW-1Y 10 sayfaları. Multiple filtering delay
Sayfayı Yazdır⑩
COSMIC E: FREQ - Setting of Cosmic Filter Frequency
Selects the frequency of Cosmic filter used in Cosmic Mode E. The delay sound converges toward the set
frequency band.
Parameter 300 Hz to 1454 Hz (default value: 1297 Hz)
⑪
FB LIMIT - Setting of Feedback Output Limit
If a large feedback amount is set, the volume increases every time the loop is repeated. This parameter limits
the output level to avoid sending signals with excessive levels to the gear connected after this unit.
Parameter -50 dB to 0 dB (default value: -20 dB)
⑫
DRY - Setting of Dry Sound
Sets how the input signal (dry sound) is output.
Parameter ON (default): Dry sound is output.
OFF: Dry sound is muted and only the delay sound is output.
NOTE
When OFF is selected, the dry sound is muted even when the effect is OFF.
⑬
EXP CALB - Calibration of Expression Pedal
An expression pedal connected to the EXP/CV/FS terminal can be used to adjust a COSMIC WAVE's parameter
in real time. Since expression pedals have various operating characteristics, the COSMIC WAVE can calibrate
the expression pedal to be used. Use an expression pedal with variable resistance from 10 kΩ to 25 kΩ.
1. Select the EXP CALB screen.
2. Connect your expression pedal to the EXP/CV/FS terminal.
3. Press the SAVE switch.
4. The screen highlights "TOE MAX." Set the expression pedal to its toe side end (max.) and press the SAVE
switch.
5. The screen highlights "HEEL MIN." Set the expression pedal to its heel side end (min.) and press the SAVE
switch.
6. The calibration process completes when the display shows "EXT CALB IS DONE."
⑭
EXP DISP - Display of Expression Pedal
This screen sets whether the screen shows the parameter changed by operating the expression pedal.
Parameter ON (Default): The parameters are shown on the screen.
OFF: The parameter display function is disabled
14
⑮
Initializing
Use this function to reset the unit to the factory shipment setup status. Please be careful when using this as all of
the user presets will be cleared.
1. In the Global Setup screen, select [15] INITIALIZE.
2. Confirm that the SAVE LED is flashing and press the SAVE switch.
3. The display shows "INITIALIZING..." when the initialization starts.
4. The Global Setup screen reappears when the initialization is completed.
⑯
FIRMWARE - Firmware Update
Users can update the COSMIC WAVE's firmware to the latest one.
For the latest firmware, instructions for update and connection, please visit the product page or support page in
our website.
Usage of EXP/CV/FS Terminal
A standard expression pedal can connect to the EXP/CV/FS terminal by using a TRS cable.
For the functions that can be assigned to an expression pedal, refer to "List of Assignable Functions."
Expression Pedal Requirements
Recommended resistance value: 10 kΩ to 25 kΩ
TIP: Wiper of expression pedal (output)
RING: Power (5 V is supplied from COSMIC WAVE)
SLEEVE: GND
NOTE: For recommended expression pedals, refer to Free The Tone website.
The EXP/CV/FS terminal accepts the control voltage (CV) with the range of 0 to 5 V. To connect, use a monaural
phone cable.
15