AudioControl ESP-3 Kullanıcı ve Kurulum Kılavuzu - Sayfa 5

Amplifikatör AudioControl ESP-3 için çevrimiçi göz atın veya pdf Kullanıcı ve Kurulum Kılavuzu indirin. AudioControl ESP-3 17 sayfaları. Image amplifier

Sayfayı Yazdır

HOW TO INSTALL THE AUDIO CONTROL ESP·3

Before we dig into this, we want to give Professional Installers another plug. They can

do a great job of installing the ESP-3 and your new center channel speaker. We're just

pointing out that installers have a lot of experience and exactly the right tools.

In addition, the ESP-3 includes a third channel. Determining the right kind of speaker,

power amplifier and

level

match with left and right main front channels is best done with

the benefit of some experience -

not to mention a professional spectrum analyzer such as

the AudioControl Industrial SA-3050A.

That said, we'll proceed to ...

THE

MOST IMPORTANT INSTRUCTION OF ALL

Fill out the WARRANTY CARD and mail it in!

It's also critical that you keep your invoice or sales slip

to establish the date when you purchased your ESP-3,

and

hence

your warranty. It's also good insurance

proof should a car thief take a fancy to your system.

Insurance companies are notably reluctant to believe

something as esoteric as the ESP-3 was part of a

system.

B. PLACEMENT AND MOUNTING OF THE ESP-3 MAIN UNIT

Placement. Theoretically, you can place the ESP-3 anywhere that it can receive

power. The most convenient places are under the dash, under the seats or

the

trunk.

While the ESP-3 has been designed with very rugged parts, and

engineered

in a manner

which reduces physical circuit board stress, be sure to consider the following guidelines:

Avoid mounting the ESP-3

near

a heater, in front of the firewall or anywhere else

where it can get really hot.

The

mounting location must be safe from water seepage. Lots of trunks have seal prob-

lems (poor gaskets, not sleek, furry mammals who balance beachballs and eat mackerel at

the zoo). Check for old water stains.

Make sure the ESP-3 can be firmly mounted without vibration. This protects connec-

tions from breakage and stress as well as the possibility of it coming UN-attached when you

blast over a speed bump.

Avoid any location where mounting screws may potentially pierce a gas tank (lots of

which are in the vicinity of the trunk) or gas, brake or electrical lines.

Mounting. The

ESP-3

installs just like a power amplifier, secured by four screws and

lock washers through the four slots in the unit's base.

First place the ESP-3 in

its

mounting position and mark the four screw holes.

Try

to keep them to the outsides of the slots

possible.

Now remove the ESP-3 and drill four small pilot holes. This will insure accuracy

and guard against stripping out the larger holes to come.

Drill the larger holes.

Replace the ESP-3 and secure tightly with four sheet metal screws and lock washers.