AudioControl ESP-3 Kullanıcı ve Kurulum Kılavuzu - Sayfa 6

Amplifikatör AudioControl ESP-3 için çevrimiçi göz atın veya pdf Kullanıcı ve Kurulum Kılavuzu indirin. AudioControl ESP-3 17 sayfaları. Image amplifier

Sayfayı Yazdır
C. PlACEMENT AND
MOU
NTIONG OF THE ESP-3
IMAGE
CONTROL
The Image Control may be mounted under the dash using its own bracket or through
the dash
without
the bracket. It should be within reach of the driver and where the indicator
LED is plainly visible.
Under-dash
Installation. The Image Control mounts with four screws which attach to the
underside of the dashboard. Since you 're going to need to slide in upside down to get a clear
view of the nether parts of the dash, it's handy to have a Faithful Assistant to hand you
things.
1.
First slide into the car and place the Image Control in its potential mounting
position (this is starting to sound
kinky).
Now ask for "Forceps" and then tell your assistant
you're just kidding and want the pencil
instead.
2.
Mark the four holes and remove the Image Control.
3.
Drill four holes into the dashboard underside.
4.
Replace the Control and secure it with four screws.
In-Dash
Installation. For that
custom,
finished look (or if under-dash mounting just
isn't practical), the Image Control can be mounted directly into the
dashboard.
We have
provided an extra label and LED holder to make this easier. A small hex driver, medium
screwdriver,
pliers,
and power drill with 9/32", 13/64" and 1/8" bits are required ... along
with some patience and
delicacy.
1.
You
will need to disassemble the ESP-3 Image Control. First gently pull the LED
assembly from its black plastic holder
on
the Image Control bracket. Do not remove the
actual LED wires from its connector, if possible.
2.
Next, remove the circuit board and rotary controls from the
bracket.
Take off the
knobs by loosening their set screws, then unscrew the lock nuts and washers.
3.
Now take a deep breath and using the label as a template, drill two 9!32" holes in
the dashbOard (if this is a burlwood Rolls Royce dash, you
're
a very gutsy person).
4.
Drill 1/8" holes for the lock tabs.
Or
remove the lock tabs if you're sure you can
keep the circuit board from
rotating.
5.
Drill a 13/64" hole for the LED.
6.
Apply the pressure-sensitive label.
7.
Remove the black plastic LED holder from the Image Control bracket and push it
into the 13/64" hole.
8.
Insert the rotary control/circuit board into the 9/32" hole, and the LED assembly
into its black plastic
holder.
Make certain the red wire on the connector goes to the long
lead of the
LED.
9.
Check for any parts of the LED wires or circuit board touching metal and then replace
the lock nuts and washers and tighten securely.
6