AudioControl DQ-61 Manuel - Sayfa 2
Medya Dönüştürücü AudioControl DQ-61 için çevrimiçi göz atın veya pdf Manuel indirin. AudioControl DQ-61 19 sayfaları. Six channel line output converter with signal delay, equalization and accubass for interfacing with factory installed audio systems
Sayfayı Yazdır
Quick Install Guide
If you are a seasoned audio enthusiast and are chomping at the bit to begin
your experience with the DQ-61, we offer some Quick Install Guidelines below
to help maximize your experience. Please refer to the system diagrams on page
8 as good guidelines.
1 Physically mount the DQ-61 in a location that keeps it away from bever-
age spills, food crumbs, and curious fingers. You will want to select a location
that allows you access to the top panel controls. In many cases you can find
factory speaker leads in the rear of the vehicle or at the factory amplifier that
are easy to access.
2 The DQ-61 needs to be installed in the signal path between your OEM
source unit (or factory amplifier) and an after-market amplifier and/or
processor(s). Do not connect the DQ-61 between the factory head unit and
the factory amplifier. Locate the amplified speaker wires that are coming from
your factory source unit and/or amplifier and connect them to the speaker-level
inputs on your DQ-61.
Note: If your source unit has front, rear, and subwoofer speaker-level out-
puts, connect them to the three sets of inputs on your DQ-61. If the source unit
only has front and rear outputs, the Auto Mode circuitry in your DQ-61 auto-
matically routes the Channel 2 input channels to the (Channel 3) subwoofer
channels.
3 Use RCA connecting cables to connect the RCA outputs of the DQ-61 to
your after market amplifier(s). If this is not obvious to you, quickly pack up
your DQ-61 and run to your nearest authorized AudioControl dealer to have
them perform the installation. You will thank us later.
4 Connect +12 volt power, ground and turn-on wires as needed. Don't forget
the fuse! Note: The DQ-61 has a 12-volt trigger input but normally you will
just let the GTO turn on circuit take care of that by itself.
5 Connect your amplifier trigger input to the 12-volt trigger output of the
DQ-61
6 Turn your amp gains fully down before turning on the system.
7 Turn on the system and level match your DQ-61 to your source unit and
amplifiers.
8 On the chassis of the DQ-61, set Signal Delay Mode to Set-Up.
9 Using the Dash Control, adjust the signal delay between the Left and Right
channels for optimum sound. Check out our YouTube video for assistance.
0 Tap the ACR-3 Dash Control and adjust the signal delay between the front
and subwoofer outputs.
On the chassis, change Signal Delay Mode to Normal.
page 2