AudioControl LC6 Kullanıcı El Kitabı - Sayfa 4
Medya Dönüştürücü AudioControl LC6 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. AudioControl LC6 16 sayfaları. Six channel line output converter
Sayfayı YazdırQuick Installation Information
For those of you short on time but high on ambition, we offer the
following section to speed up your installation of the LC6:
1. Physically mount the LC6 in a location that keeps it away from soda
spills, food crumbs, and curious fingers. You will want to select a
location that allows you access to the level controls. In many cases you
can find factory speaker leads in the rear of the vehicle that are easy to
access.
2. The LC6 needs to be installed in the signal path between your OEM
source unit or factory-installed amplifier and an external amplifier and/or
processor(s). Locate the speaker wires that are coming from your factory
source unit and/or amplifier and connect them to the speaker-level inputs
on your LC6.
3. Connect the Output RCA connectors to cables that run to your
external signal processors and/or amplifiers. If this is not obvious to you,
quickly pack up your LC6 and run to your nearest authorized
AudioControl dealer to have them perform the installation. You will
thank us later.
4. Connect +12 power, ground, and remote turn-on (if applicable).
5. Level match your LC6 to your source and amplifiers.
Note: You will want to turn the gains DOWN on your aftermarket
amplifiers to maximize your systems performance and minimize any
HISS!
Figure 1: Basic LC6 System
If you need to know more, then read on. Heck, if you don't need to
know more, still read on, because you can never know too much...plus
we spent a lot of time writing this manual!
page 4