AudioControl LC6 Kullanıcı El Kitabı - Sayfa 2

Medya Dönüştürücü AudioControl LC6 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. AudioControl LC6 16 sayfaları. Six channel line output converter

Sayfayı Yazdır

Features and Highlights

Speaker-Level Inputs

If you are like many people who like the look and features of their

factory-installed source unit but feel it's lacking power and bass, we have

good news. The LC6 has high-impedance speaker-level inputs that allow

it to accept amplified signals from most factory-installed source units

(even Bose) and output a high-quality pre-amp signal via standard RCA

connectors. This will allow you to add better-quality amplifiers, proces-

sors and speakers while keeping the convenience features of your

factory-installed source unit. Unlike "inexpensive" speaker-level and

line-output converters available, the LC6 offers high sound quality and

can handle the full signal strength of a 400-watt amplifier.

Signal-Sensing Inputs

Most engineers of factory-installed source units lack the common

decency to include features that make it easy to upgrade with really

good-sounding, performance after-market products. One of those key

features is a 12-volt trigger that will turn on devices like the LC6 and

your external amplifiers. Therefore, we have equipped your LC6 with

signal sensing inputs, which means once it detects a speaker-level signal

at its inputs, it will power up. When you turn off the your source unit

and the speaker-level signal goes away your LC6 will automatically turn

off after a few minutes. This turn-off delay is in case you are changing

CD's or your radio station is quiet for a few moments and you then you

don't really want your system to turn off. Optionally, your LC6 is also

equipped with a standard 12-volt trigger (Remote In) that will allow you

to turn on your LC6 in the traditional manner.

12-Volt Trigger Output

Since you will be using an external amplifier and processor in your

system, you will need the ability to "trigger" or turn-on these devices (a

romantic dinner won't quite work here). Your LC6 has a 12-volt output

trigger (labeled "Remote Out") that will provide a 12-volt output to

trigger these remote devices, when the LC6 is powered up. Please note

that this output is not to be used as power for these devices.

AutoMode Inputs

Sometimes in life (and car audio) we need more outputs than inputs.

Therefore we have equipped your LC6 with AutoMode inputs that take

the rear-channel signal and automatically feed it to the subwoofers, when

there is no signal present on the subwoofer inputs. This means your LC6

will accept two input channels and give you four output channels. Or it

can accept four input channels and give you six output channels. (See

Figure Six.)

page 2