Duplo DBM-120 Kurulum Kılavuzu - Sayfa 11

Katlama Makineleri Duplo DBM-120 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Duplo DBM-120 13 sayfaları. Connecting kit model: dc-6000s;dc-8000s 2; dc-10000s
Ayrıca Duplo DBM-120 için: Kurulum Kılavuzu (12 sayfalar)

Sayfayı Yazdır

2. INSTALLING PROCEDURE

Check that the distance between the

paper in-feed slot of the DBM-120 and the

LU-HM exit is 8 to 12 mm (0.31" to 0.47").

NOTE

: As the above range will not be satisfied if

the ground is not flat, check that the

ground is flat.

Adjust the height of the LU-HM exit so that

the paper in-feed slot of the DBM-120 is 3

to 7 mm (0.12" to 0.28") lower than the

LU-HM exit.

q Loosen the top two screws of the pillars of both the

operating and non-operating sides.

w Loosen the nut fixing the bolt inside the pillar, and

turn the bolt to adjust the height of the LU-HM exit.

NOTE

: Adjust so that the operating and non-

operating sides of the LU-HM exit

become the same height.

e After adjusting, tighten the nut, secure the bolt, and

tighten the top screws of the pillar.

DBM-120

Guide

8 to 12 mm

(0.31" to 0.47")

DBM-120

Guide

Pillar

Screws

Down

LU-HM

Paper ejection rollers

LU-HM

Paper ejection rollers

Fixing nut

Bolt