Conqueror FBC200 Kullanıcı Kılavuzu - Sayfa 6

Garaj Kapısı Açıcı Conqueror FBC200 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Conqueror FBC200 18 sayfaları.

GARAGE DOOR OPERATOR USER'S MANUAL

5. Installation and adjustment

Step1

Check the door is in good working condition, manually open and close the door to make

sure the door operates smoothly and freely.

The door must be well balanced.

Check to see if there is a solid frame in the wall above the center of the door.

Close the door.

Measure the door width, mark the centerline of the door using a pencil, and extend the

line down to the door surface, then up the wall above the door.

Check the installation height of the operator. Slowly open garage door and observe the

highest point of door while moving. Close the door again and mark this highest point on

the wall, mark a horizontal line across the vertical centerline around 40mm above the

highest point. (Note: there should be 80mm space between this horizontal line to the

ceiling. If there is not enough space, please use the max height possible to allow the

header bracket to be fitted properly. )

Sectional door

Fit the header bracket to the wall above the door, the centerline of the door should align

with the centerline of the bracket the bottom edge of the bracket should align with the

horizontal line. Fix the header bracket to the wall with expansion bolts.

Garage door

Fig.2

Highest point

Fig.3

Highest point

Tilt door