Belden FX FUSION SC CONNECTOR Kurulum Kılavuzu - Sayfa 7
Kablolar ve konektörler Belden FX FUSION SC CONNECTOR için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Belden FX FUSION SC CONNECTOR 8 sayfaları. 900μm tight buffer/250μm
Ayrıca Belden FX FUSION SC CONNECTOR için: Kurulum Kılavuzu (8 sayfalar)
Sayfayı Yazdır
16.
Carefully slide the splice
protection sleeve to have a
portion of the buffer cleaved
fiber and the ferrule stub
assembly covered.
IMPORTANT:
protection sleeve must
completely cover the first
portion of the ferrule stub
assembly as shown below.
FX FUSION SC CONNECTOR
900µm TIGHT BUFFER/250µm - INSTALLATION GUIDE
The splice
17.
Place the cable assembly into
the splicer heater and follow the
manufacturer's instructions and
Belden's heat settings.
Heat the splice protection
sleeve.
18.
Remove the cable assembly
from the heater after the
shrinkage is completed.
PX106500-EN REV E
Page 7 of 8